Input Power Configuration - Assa Abloy Norton 5700P Series Installation Instructions Manual

Input Power Configurations
1. Thread conduit fitting into backplate.
Concealed Wiring (Figure 26)
Surface Wiring (Figure 27)
NOTE:
• This conduit fitting is for low voltage
control wiring only.
• Check local codes.
2. Pull conduit out of header and attach to
conduit fitting before mounting unit.
3. After installing operator, attach low
voltage wiring as illustrated. (Figure 27)
NOTE: Ground wire must be secured to
backplate under head of (green) ground
screw.
WARNING: HOT and COM of T1
Terminal Block are factory use for
incoming power ONLY. These are
not to be handled in the field.
12
Figure 27
Copyright © 2016, 2019-2020, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in
whole or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
Approved 2020-01-27
5700P Series Power Operator
Figure 26
Figure 28
80-9357-0009-020 Rev 7 01/20