Power Connections - Assa Abloy Norton 6011 Series Installation Instructions Manual

Power Operator
1. Open door on union assembly and place selector mode switch
in 'OFF' position. (Figure 26)
2. Turn On/Off switch to 'OFF' position on conduit assembly.
(Figure 27)
3. Turn on building power.
4. Turn On/Off switch to 'ON' position on conduit assembly.
See page 15 for controller adjustment options.
• To scroll through menu items, push up or down on joystick.
(Figure 27)
• To change setting of a menu item, when cursor is on that
item, push joystick right to increase or left to decrease value.
NOTE: Values will auto-save 3 seconds after adjustments.
5. Set 'HOME' procedure for door.
• With door closed and selector mode switch of union
assembly in "OFF" position, use joystick to scroll down menu
on LCD screen to "Home".
• Push in on joystick to activate menu feature. Display changes
to "Set Close Limit".
• Push in on joystick again, while door is still closed, to set
Home or closed position (Figure 28). Display changes to "Set
Open Limit".
• Open door to desired open position (Figure 28) and push in
on joystick again. Display changes to "Closing to Home".
• Allow door to fully close again (Figure 28). Display changes to
"Home".
NOTE: Values will auto-save.
6. Make necessary adjustments to inverter and add required
accessories.
7. Place selector mode switch of union assembly in 'ON' position
for activation by push plate, RF button, or other activation
devices. Place switch in 'H/O' for continuous hold open.
(Figure 26) Secure union assembly door with #4 Phillips screw
when finished.
You've now installed the 6011 or 6051 PULL SIDE Low Energy Operator.
Continue with Electrical Instructions to customize the installation.
12
WARNING: Door may begin to move
immediately when power is applied to unit.
An open union assembly door has potential to
pinch fingers if hand is not withdrawn quickly
when switching on power.
WARNING: Door may begin to move immediately when
selector mode switch is changed. An open union assembly
door has potential to pinch fingers if hand is not withdrawn
quickly when adjusting switch.
6011/6051 Series (Pull Side) Power Operator
Figure 27
Figure 28
Copyright © 2019, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
Selector
Mode
Switch
Figure 26
Union Assembly and Spacer not shown
80-9360-1026-020 Rev 4 11/19