5500 Series Power Operator - PUSH SIDE Installation
Input Power Configuration
1 .
Thread conduit fitting(s) into backplate.
Concealed Wiring (Figure 14)
Surface Wiring (Figure 15)
NOTE:
• A second conduit fitting is required
for low voltage control wiring.
• Check local codes.
2 .
Pull conduit out of header and attach to
conduit fittings before mounting unit.
3 .
After installing operator, attach incoming
ground wire to backplate with ground
screw as illustrated . (Figure 15)
NOTE: Ground wire must be secured to
backplate under head of (green) ground
screw.
Copyright © 2021, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or in
part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
80-9355-0007-020 Rev 1 03/21
Conduit
by Others
(from top)
Power
Ground
Leads
Lead
Figure 15
Approved 2021-04-16
Low Voltage
Control
Wiring
Figure 14
Ground
Screw
Cable
(Green)
Clamps
Optional Bracket
3A Fuse
(for surface wiring)
Incoming
Power
Power Input
Terminals
HOT
COM
9