Assa Abloy Besam SW200i US Installation And Service Manual page 50

12 Electrical connection
j Cut off the white (8) and the green (9) wires from the Rocker Switch cable (10), being
careful not to nick other wires.
k Strip the white (11) and the green (12) wires from cable (1). Leave these two wires uncon-
nected and cut off the remaining black wire (17) from cable (1).
l Only the following wires should now be unconnected;
- white wires (11) + (16) and green earth wires (12) + (14) + (18)
- black wire (13) from the Rocker Switch cable
m See Installation Manual (1007718), chapter Electrical Connection, section Connection box,
how to connect the mains power supply cable to the Master Connection box.
n Place the wires in the Master Connection box. Fasten the covers on both Connection boxes
and connect the Interconnection cables to the control unit.
Note: Connect the sync cable (Kit No. 1008552) in between the two control units and apply
an "Electrician Notice" label (19) to the cover of the Master mains power connection box.
Tip: For convenience tape together 1" from the ends of the following wire combinations in
the Master mains power connection box: Whites (11) + (16), Greens (12) + (14) + (18),
Black should be a single wire.
50
Slave
19
Electrician Notice!
Mains Power behind this cover.
Connect to White (Neutral), Black
(HOT), Green (GND)
Do not connect to RED.
Issue 2012-06-27
8
9
Cut the black wire
17
11
12
6
16
7
15
Master
1
Mains power
10
18
13
14
19
1007718-US-3.0