Classification; Entering The Program Mode (Classification); Identify The Current Classification; Changing The Classification - Assa Abloy Besam SW200i US Installation And Service Manual

15

Classification

15.1

Entering the program mode (classification)

On the master control unit.
Disconnect the mains plug
Press the LEARN BUTTON while connecting the mains plug
Watch the ERROR LED
3 s
Release the LEARN BUTTON after the second 5 s has passed
15.2

Identify the current classification

The ERROR LED flashes an amount of short flashes that correspond to the classification
number.
After a short pause the LED will repeated the classification number and so on.
15.3

Changing the classification

If you push the LEARN BUTTON once, the classification number will increase. When you
have reached the highest classification number it will start at number one again.
Push the button until you get the requested classification
Disconnect the mains plug
Next time you connect the mains the operator will use the new classification.
15.4 Classification table
Classification
Standard
Opening speed
Closing speed
The fastest setting of Opening Speed and Closing Speed are automatically limited to the value
in the table, and can only be reduced.
If the Low Energy classification is used the operator will automatically follow the speed limitation
in ANSI 156.19 (and DIN 18650-2).
The learn procedure must be carried out after a change of the classification setting.
Speed settings according to Table I in ANSI / BHMA A156.19 (LOW ENERGY APPLICATION)
1007718-US-3.0
1 s 5 s 1 s
1
Full power
ANSI 156.10
2-12 s
4-12 s
Issue 2012-06-27
5 s
2
Low energy (Default)
ANSI 156.19 (and DIN 18650-2)
Automatic limitation, 3-12 s
Automatic limitation, 4-12 s
15 Classification
69