Glazing Materials - Assa Abloy Besam SW200i US Installation And Service Manual

2 Important information
The equipment may generate and use radio frequency energy and if not installed and used
properly, it may cause interference to radio, television reception or other radio frequency type
systems.
If other equipment does not fully comply with immunity requirements interference may occur.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Re-orient the receiving antenna.
Relocate the receiver with respect to the equipment.
Move the receiver away from the equipment.
Plug the receiver into a different outlet so that equipment and receiver are on different branch
circuits.
Check that protective earth (PE) is connected.
If necessary, the user should consult the dealer or an experienced electronic technician for addi-
tional suggestions.
Besam products are equipped with electronics and may also be equipped with batteries containing
materials which are hazardous to the environment. Remove this material from the operator before
it is scrapped and make sure that it is disposed of properly as was done with the packaging.
This manual contains the necessary details and instructions for the installation, maintenance
and service of the Swing Door Operator Besam SW200i.
2.4

Glazing materials

The glazing material for swing doors shall comply with ANSI Z97.1
6 Issue 2012-06-27 1007718-US-3.0