Detection Settings; Operation Mode - Panasonic HG-T Series User Manual

6.3 Detection Settings (

This function allows you to set an operation mode, the direction of insertion, and average count
according to the shape or application of the measured object.

6.3.1 Operation Mode (

Set an operation mode according to the measurement method for the object to be measured.
Operation mode
Auto edge detection mode (AT.
EDGE)
Edge detection mode (EDGE)
External form/width detection
mode (OUT.WD)
Inside diameter/gap detection
mode (IN.GAP)
Central position detection
mode (CEN.POS)
For details on each operation mode, refer to "5.4 Operation Mode".
Setting method
Hold down for 2 seconds
: Finalize
Setting item
Operation mode (OP.MODE)
WUME-HGT-3
)
This mode automatically recognizes the direction in which the
measured object enters the measurement area of the sensor
head (TOP or BOTTOM side). The distance from the edge of
the side where the measured object enters the measurement
area to the edge of the measured object is measured.
When the direction in which the measured object enters the
measurement area of the sensor head is specified as the
TOP or BOTTOM side, this mode measures the distance from
the TOP or BOTTOM side of the measurement area to the
edge of the measured object.
This mode measures the external form or width of the mea-
sured object.
This mode measures the inside diameter or gap of the mea-
sured object.
When an object such as a pin is measured, this mode mea-
sures the distance from either the TOP or BOTTOM side to
the center of the measured object.
: Select
Auto edge detection mode (AT.EDGE)
Edge detection mode (EDGE)
External form/width detection mode (OUT.WD)
Inside diameter/gap detection mode (IN.GAP)
Central position detection mode (CEN.POS)
Setting up General Functions
)
Function
Setting range
Measurement
direction setting
Not required
Required
Not required
Not required
Required
Default value
AT.EDGE
6-9