Specifications; Controller - Panasonic HG-T Series User Manual

Specifications and Dimensions

8.1. Specifications

8.1.1 Controller

Type
NPN output
Model No.
PNP output
Number of connectable
units
Supply voltage
Current consumption
(Note 2)
Analog volt-
Analog
age output
output
(Switching
type)
Analog cur-
(Note 3)
rent output
Control output
(Output 1 / Output 2 /
Output 3)
Short-circuit protection
Judgment output
Alarm output
External output switching
External input
(Input 1 / Input 2 /
Input 3)
Trigger input
Laser emission stop
input
Preset input
Reset input
Bank input A / B
8-2
Master unit
High-performance type
HG-TC101
HG-TC101-P
Up to 15 slave units can be connected to a master unit. (Up to 14 slave units can be
connected if a communication unit is connected.)
24VDC ±10%, including 0.5V ripple (P-P)
100mA or less (when sensor head is connected)
• Voltage output range: 1 to 5V / F.S. (default value)
• Output when alarm occurs: 5.2V
• Linearity: ±0.05% F.S.
• Output impedance: 100Ω max.
• Current output range: 4 to 20mA / F.S. (default value)
• Output when alarm occurs: 0mA
• Linearity: ±0.25% F.S.
• Load impedance: 250Ω max.
<NPN output type>
NPN open-collector transistor
• Maximum sink current: 50mA (Note 4)
• Applied voltage: 30VDC or less (between output and
0V)
• Residual voltage: 1.5V or less (at 50mA sink current)
• Leakage current: 0.1mA or less
<PNP output type>
PNP open-collector transistor
• Maximum source current: 50mA (Note 4)
• Applied voltage: 30VDC or less (between output and
+V)
• Residual voltage: 1.5V or less (at 50mA source cur-
rent)
• Leakage current: 0.1mA or less
Incorporated (automatic reset type)
N.O. / N.C switching type
Open when alarm occurs
Output 1, Output 2, and Output 3 can be switched to
3-value, 2-value, Logic, and Logic 2.
<NPN output type>
Non-contact input or NPN open-collector transistor
• Input conditions
Invalid: +8V to +VDC or open
Valid: 0 to +1.2VDC
• Input impedance: Approx. 10kΩ
<PNP output type>
Non-contact input or PNP open-collector transistor
• Input conditions
Invalid: 0 to +0.6VDC or open
Valid: +4 V to +VDC
• Input impedance: Approx. 10kΩ
Input time: 2ms or more (ON)
Input time: 20ms or more (ON)
Input time: 20ms or more (ON)
Input time: 20ms or more (ON)
Input time: 20ms or more (ON)
Slave unit
HG-TC111
HG-TC111-P
Wire-saving type
HG-TC113
―
―
―
―
―
WUME-HGT-3