Calculation Settings ( )(For Master Units Only); Calculation Mode - Panasonic HG-T Series User Manual

Setting up Extended Functions
7.3 Calculation Settings (
This function can perform calculation processing based on the measured values of the connect-
ed controllers and display the judgment results in the digital display section of the master unit or
output them from the master unit.
<Reference>
● When performing calculation settings, be sure to connect slave units to the master unit.
If no slave unit is connected to the master unit, "MODE" (calculation mode) and "APPLI" (calcu-
lation application selection) will not be displayed.
● The calculation setting menu is only displayed for master units.

7.3.1 Calculation Mode (

In calculation mode, you can specify whether to perform calculations.
Calculation mode
No calculation (NOCALC)
Calculation execution (CALC)
Setting method
Hold down for 2 seconds
Setting item
Calculation mode (MODE)
7-48
)(For Master Units Only)
)
Each slave unit connected to the master unit can be operated individually without
performing calculations.
This function can use the specified application to perform calculation process-
ing for the measured values of the master unit and the slave units connected
to it and display the judgment results in the display section of the master unit or
output them from the master unit.
CALC: Displayed for master units only
: Select
: Finalize
No calculation (NO.CALC)
Calculation execution (CALC)
Function
Set value Default value
NO.CALC
WUME-HGT-3