Panasonic HG-T Series User Manual page 67

If auto edge detection mode is set, the base position will be switched according to the direction
(TOP or BOTTOM side) in which the measured object enters the measurement area of the sen-
sor head, causing the HIGH and LOW set values to be switched.
Example of switching between HIGH and LOW set values
●
<When the measured object enters the measurement area from the TOP side>
TOP side
Emitter
<When the measured object enters the measurement area from the BOTTOM side>
Emitter
BOTTOM side
• When the measured object enters the measurement area from the TOP side, LOW set value
2.0mm is used. When the measured object enters the measurement area from the BOTTOM
side, LOW set value 2.0mm is switched to HIGH set value 8.5mm.
• When the measured object enters the measurement area from the BOTTOM side, HIGH set
value 7.0mm is used. When the measured object enters the measurement area from the
TOP side, HIGH set value 7.0mm is switched to LOW set value 3.5mm.
<Reference>
● If auto edge detection mode is set, the upper limit for measured values is 10.5 mm.
WUME-HGT-3
Measured
object
Edge
Receiver
Edge
Measured Receiver
object
Reference position: 0mm
LOW set value: 2.0mm
HIGH set value: 7.0mm
Upper limit value: 10.5mm
Upper limit value: 10.5mm
HIGH set value: 8.5mm
LOW set value: 3.5mm
Reference position: 0mm
Basic Usage
5-23