<When 3-point teaching is selected>
1.
Hold down the
creases.)
2.
"SET.1" appears in the digital display section / SUB (green), and the digital display section /
MAIN (white) blinks.
3.
Measure the HIGH-side defective workpiece and press the
4.
"SET.2" appears in the digital display section / SUB (green).
Measure the good workpiece and press the
5.
"SET.3" appears in the digital display section / SUB (green).
Measure the LOW-side defective workpiece and press the
5-20
key for 2 seconds. (The number of lit increments in the circle meter in-
key.
key.
key.
Basic Usage
WUME-HGT-3