Detection Settings; Operation Mode - Panasonic HG-T Series User Manual

6.3 Detection Settings (

This function allows you to set an operation mode, the direction of insertion, and average count
according to the shape or application of the measured object.

6.3.1 Operation Mode (

Set an operation mode according to the measurement method for the object to be measured.

Operation mode

Auto edge detection mode
(AT.EDGE)
Edge detection mode (EDGE)
Outer diameter/width detection
mode (OUT.WD)
Inner diameter/gap detection mode
(IN.GAP)
Central position detection mode
(CEN.POS)
User assigned edge detection mode
(USR.EDG)
For details on each operation mode, refer to
■
Setting method
Setting item
Operation mode (OP.MODE)
WUME-HGT-6
)
)
Function
This mode automatically recognizes the direction in
which the measured object enters the measurement
area of the sensor head (TOP or BOTTOM side). The
distance from the edge of the side where the
measured object enters the measurement area to the
edge of the measured object is measured.
When the direction in which the measured object
enters the measurement area of the sensor head is
specified as the TOP or BOTTOM side, this mode
measures the distance from the TOP or BOTTOM side
of the measurement area to the edge of the measured
object.
This mode measures the outer diameter or width of the
measured object.
This mode measures the inner diameter or gap of the
measured object.
When an object such as a pin is measured, this mode
measures the distance from either the TOP or
BOTTOM side to the center of the measured object.
When the measured object enters the detection area
of the sensor head, this mode measures the distance
between two edges that are optionally specified.
"5.4 Operation
Setting range
Auto edge detection mode (AT.EDGE)

6.3 Detection Settings (

Mode".
)
Measurement
direction
setting
Not required
Required
Not required
Not required
Required
Not required
Default value
AT.EDGE
6-9