Settings On The Base Screen (Using Shortcut Keys); Display Switching Mode - Panasonic HG-T Series User Manual

5.5 Settings on the Base Screen (Using Shortcut Keys)

This section explains other functions that can be used from the base screen.

5.5.1 Display Switching Mode

<Overview>
You can change the display of the digital display / SUB (green) as needed for the task.
For example, if you select "Sensor head measured value", the actually measured value and
judgment value can be simultaneously compared and displayed, making it easy to check the
state of sensor head measurement.
<Settings>
1. Normal measured value (default value)
7. Measurement direction
Name
Normal measured
1
value
Calculated value
2
(Note)
3 Label
4 LOW set value
5 HIGH set value
Sensor head mea-
6
sured value
Measurement
7
direction
WUME-HGT-3
2. Calculated value (Note 1)
6. Sensor head measured value
Digital display
SUB (green)
Shows the normal measured value.
• When using the hold function, you can check internal
measured values that are not held.
Shows the calculated value.
• When using the calculation function and hold function,
you can check calculation results that are not held.
You can view and set any values or characters.
• This saves you the trouble of attaching sensor number
and other labels on the controller.
Shows the LOW set value.
• You can check the judgment value and lower limit value
at the same time.
Shows the HIGH set value.
• You can check the judgment value and upper limit val-
ue at the same time.
Shows the measured value from the sensor head.
• When using the preset or calibration function, you can
check the actual pre-correction measured value.
Shows the direction in which the measured object is in-
serted.
You can check that the direction is the TOP or BOTTOM
side.
3. Label
4. LOW set value
5. HIGH set value
Description
Basic Usage
Factory
default state
Default state
–
–
–
–
–
–
5-27