Attaching The Sensor Head - Panasonic HG-T Series User Manual

Installation and Connections

4.2 Attaching the Sensor Head

● The light emitting and receiving surfaces of the sensor head must be free of water, oil,
fingerprints, and other substances that refract light as well as dust, grit, and other objects
that intercept light.
If stains or dirt become attached to the sensor head surfaces, wipe them with a lint-free
soft cloth or lens cleaning paper. If the surfaces are very dirty, wipe off dirt using a cotton
swab (or similar material) moistened with absolute alcohol.
● A serial number is marked on each opposite surface of the light emitting and receiving
surfaces of the sensor head.
Use a pair of emitter and receiver that have the same serial number.
Use M3 screws (to be prepared by the customer) to mount the sensor head.
Tighten the screws to a torque of 0.5N·m.
8mm
Beam axis
Serial number
(Marked on the opposite
surface of light emitting or
receiving surfaces)
4-4
M3 screw (purchase
separately)
Mounting hole dimensions
• HG-T1010
<Emitter>
24mm
The mounting holes on the emitter and re-
ceiver are bilaterally symmetrical.
• HG-T1110
<Emitter>
24mm
The mounting holes on the emitter and re-
ceiver are bilaterally asymmetrical.
<Receiver>
24mm
<Receiver>
14mm
WUME-HGT-3