Power On And Check - Keysight Technologies N9322C User Manual

Getting Started

Power On and Check

Power On and Check
N O T E
16
1
Connect the AC power cord into the instrument. Insert the
plug into a power socket provided with a protective ground.
Set the tilt adjustors for your preference.
Figure 1 Plug in and angle adjustment
2
Press the AC line switch
LED on the front panel will light and the spectrum analyzer
is in standby mode (AC power applied).
3
Press the standby switch
will light, and the spectrum analyzer boots up.
Self- initialization takes about 25 seconds; the spectrum
analyzer then defaults to the menu mode. After power on,
let the spectrum analyzer warm up for 45 minutes for
stabilization.
The front panel switch is a standby switch only; it is not a power
switch. To completely disconnect the spectrum analyzer from the AC
line power, shut off the power switch on the rear panel.
on the rear panel. The standby
on the front panel. The On LED