Keysight Technologies N9322C User Manual page 113

2 Set a folder named N932xDATA in a USB disk and put
the saved correction file in. Insert the USB disk on top
panel for further loading.
3 Press Amplitude > More > Corrections to acess the correction
function.
4 Press Cable/Antenna/Other/User to select the corrction type.
5 Press Recall to load this correction fie. The correction file
name will be shown on the Correction1 softkey and the
Apply Corrections is set to On automatically which indicates
the amplitude compensation has been applied to the
displayed trace.
Press Apply Corrections off to turn off all the corrections.
Set Antenna Unit to On to switch to graticule unit from dBm
to dBmV/m for field strength measurement.
Key access: Ampiltude > More > Correction
Impedance
Toggles the computational input impedance between 50ohm
50ohm 75ohm
and 75ohm. This is only software function in which sets the
input impedance for unit conversions. This set affects the
results when the y axis unit is voltage or current units
(dBmV, dBμV, dBμA, V, A) but does not affect the results
when it is power units (dBm, W). The selected impedance is
for computational purposes only, since the actual impedance
is set by internal hardware to 50 ohm.
Key access: Amplitude > More > Impedance
PSD Function
Press this softkey to turn on the power spectral density
On Off
function. When it is set to On, the measurement result and
amplitude parameters will be shown in power spectral
density. The PSD function can only be enabled in Spectrum
Analysis and Spectrum Monitor mode.
Key access: Amplitude > More > PSD Funtion
Key Reference
Amplitude
105