Viewing A Signal - Keysight Technologies N9322C User Manual

Viewing a Signal

Refer to the procedures below to view a signal.
Press System > Pow on/off Preset > Preset Type > Factory to enable
1
the factory- defined preset state.
Press Preset to restore the analyzer to its factory- defined
2
state.
Connect the 10 MHz REF OUT on the rear panel to the
3
front- panel RF IN.
Setting the Reference Level and Center Frequency
Press Amplitude > 10 > dBm to set 10 dBm reference level.
1
Press Frequency > 30 > MHz to set 30 MHz to center frequency.
2
Setting Frequency Span
Press Span > 50 > MHz to set 50 MHz frequency span.
Changing the reference level changes the amplitude value of the top
N O T E
graticule line. Changing the center frequency changes the horizontal
placement of the signal on the display. Increasing the span will
increase the frequency range that appears horizontally across the
display.
Reading Frequency and Amplitude
Press Peak Search to place a marker (labeled 1) on the
1
10 MHz peak.
Functions and Measurements
Making a Basic Measurement
33