Keysight Technologies N9322C User Manual page 147

Key Reference
MODE
after changing the measurement frequency range. Normally,
the selected span should be set as close to the actual swept
frequency range.
Key access: Freq > Cal Type
Run/Hold
This softkey toggles the frequency sweep between run and
pause status.
Key access: Sweep > Run/Hold
Data->Mem
This softkey is used to store the active data trace into
memory. The trace in memory will be refreshed in the next
sweep once you press this softkey. There are three trace
refresh mode for your selection:
Data Only the activated trace is viewable. The trace
memory is not viewable.
Memory Only the trace in memory is viewable.
Data&Memory The trace both activated and in memory is
viewable.
Key access: Trace > Data->Mem
Disp Mode
This softkey allows you to set the Y axis of the graticule as
return loss, VSWR or reflection coefficient value.
Key access: Meas > Disp Mode
IIM On/Off
This softkey toggles IIM between on and off. When there is a
need to measure the antenna feed line in field, there are
probably some interference signals coupled into the device,
which will be detected as spurs in the measurement result.
When IIM is set to on, the analyzer will compensate those
spurs by IIM algorithm.
Key access: Meas > IIM
139