Initial Setting Of The Preventive Maintenance Function; Setting How To Notify - Mitsubishi Electric CR800-D Series User Manual

3.2

Initial setting of the preventive maintenance function

Set how to notify when consumption of parts is detected.
Specify the notification method (presence of warning/signal output, notification day) when the warnings
occurr.
If you have not set the notification method, upon starting the preventive maintenance function, the
[Setting] - [Synthesis] screen appears.
[Note] In the default setting, notification is disabled. Make sure to set according to your environment.

3.2.1 Setting how to notify

7
Set the notification method.
1) From the RT ToolBox3 project tree, double-click [Online] - [Maintenance] - [Preventive
Maintenance].
2) From the preventive maintenance tree, click [Setting] - [Synthesis].
* If you have not set the notification method, upon clicking [Preventive Maintenance],
the [Setting] - [Synthesis] screen appears.
2) Notification day
3) Notification
Preventive maintenance becomes available after setting the notification method.
1) Consumption degree notification method:
Set how to notify consumption of maintenance parts and overhaul parts. You can select Warning
Occurrence or Signal Output, or both.
Warning Occurrence ... A warning occurs and the error number and error message are displayed
Signal Output ... The status can be checked with dedicated output signals.
(Setting of signal numbers are required. Refer to "3.2.2 Setting signals ".)
2) Consumption degree notification day:
Warning Remaining Number of Days: Set the number of remaining days for warning to occur.
Operation Time of a Day: Set the number of hours of operation of the robot per day.
3) Consumption degree notification interval: Set the interval of notification of warning.
4) Write: Writes setting items on the robot controller.
Startup and initial settings 24
[Setting] - [Synthesis] screen
interval
according to the situation.
1) Consumption
degree
calculation
4) Writing