Internal Wlan Antenna Cables - HP EliteDesk 705 G3 Desktop Mini Maintenance And Service Manual

Internal WLAN antenna cables

The antennas route from the WLAN module to the cable connectors on the front and the rear of the computer.
To install the antennas:
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the hard drive
4. Remove the drive cage
5. Remove the fan
6. Remove the heat sink
7. Remove the power switch/light cover
8. If applicable, remove the expansion connector board
9. Remove the thermal sensor
10. Disconnect the antenna cables from the WLAN module
11. Remove the system board
12. Remove the antenna cables from their routing paths underneath the keyboard. Note the locations the
cables are taped to the chassis as shown in the following image.
48 Chapter 4 Removal and replacement procedures – desktop mini (DM) chassis
(Preparation for disassembly on page
(Access panel on page
(Hard drive on page
(Drive cage on page
(Fan on page 35).
(Heat sink on page
(Power switch/light cover on page
(Thermal sensor on page
(System board on page
19).
23).
25).
41).
(Expansion connector board on page
34).
(WLAN module on page
45).
18).
21).
44).
28).