Data Acquisition Mode Settings - Teltonika FMB001 User Manual

Gnss/gsm terminal, internal li-ion battery 3.7v, 170mah
Hide thumbs Also See for FMB001:
Table of Contents

Advertisement

FMB001 supports up to 4 sensors at the same time. For device to recognize the packets
from the sensor – it's ID must be entered in the field near the "Working mode"
TZ-BT04/05 Update frequency – determines how often data will be read from sensor.
Minimum – 120 seconds, maximum – 65535 [sec.]
BT Power level determines the aproximate range in meters of the Blue-tooth receiving
power. Aproximate ranges:
Discover BLE – discovers up to 20 surrounding BLE devices and shows their MAC, signal
strength and name.
For BLE to work, "BT Radio" must be enabled in the "Bluetooth" configuration.

5.15 Data Acquisition Mode settings

Data Acquisition Modes are an essential part of FMB001 device, it is also highly
configurable.
By configuration user defines how records will be saved and sent. There are three different
modes: Home, Roaming and Unknown. All these modes with configured data acquisition and
send frequencies depend on current GSM Operator defined in Operator list (see section 0) and
are switched when GSM operator changes (e.g. vehicle passes through country boarder).
If current GSM operator is defined as Home Operator, device will work in Home Data
Acquisition mode, if current operator is defined as Roaming Operator, device will work in
Roaming Data Acquisition mode, and if current operator code is not written in Operator list (but
there is at least one operator code in the operator list), device will work in Unknown Acquisition
mode.
This functionality allows having different AVL records acquire and send parameters values
when object is moving or stands still. Vehicle moving or stop state is defined by Stop Detection
Source parameter. There are 3 ways for FMB001 to switch between Vehicle on Stop and Vehicle
Moving modes see section 5.7.
FMB001 has 6 different modes. Operational logic is shown in Figure 14.
If there are no operator codes entered into operator list, FMB001 will work in
Unknown network mode ONLY.
1 – < 0.5
2 – 0.5
3 – 11
4 – 13
5 - 15
6 - 27
7 - 50
54

Advertisement

Table of Contents
loading

Table of Contents