Trip Settings - Teltonika FMB001 User Manual

5.12 Trip settings

Trip scenario offers user to configure Trip feature.
Start Speed – GPS speed has to be greater than the specified Start Speed in order to detect
Trip Start.
Ignition Off Timeout – timeout to wait if ignition was off, to detect Trip stop.
Continuous distance counting – Not or Continuous can be chosen. For this feature I/O
Odometer must be enabled.
Odometer calculation source – parameter by which distance will be calculated.
Odometer value – calculation start point can be set here, so that vehicle and device
odometer would match
If I/O Odometer is enabled and Continuous distance counting variable (Mode) is set to
Continuous, Trip distance is going to be counted continuously (from Trip start to Trip stop). This
value is written to I/O Odometer value field. When Trip is over and next Trip begins, Odometer
value is reset to zero. When the next trip starts counting continuously starts from the beginning
again.
If I/O Odometer is enabled and Continuous Distance Counting variable (Mode) is set
"Between Records", then the distance is going to be counted only between every record made.
This value is written to I/O Odometer value field and reset to zero every new record until Trip
stops. If later all Odometer values are summed up manually, the user gets the distance driven
during the whole period of the Trip.
Figure 21 Geofence configuration
44