Teltonika FMB001 User Manual page 49

These are instructions how to easily prepare Blue-tooth Hands Free device connection to
FMB device. First we need to configure FMB device Blue-tooth settings for proper connection to
this hands-free unit. These are required steps:
1. Connect FMB device to PC using USB cable.
2. Launch FMB Configurator and connect to device
3. After successful connection to device, current configuration will be loaded
automatically.
4. When device configuration is loaded press „Blue-tooth" settings (Figure 2.2).
5. Turn on BT Radio by pressing „Enable (visible)" (Figure 2.3). You could leave "Local
name" (Figure 2.4) box empty (then device name will automatically be "FMB001_last
7 imei digits") or type your own name.
6. Set Security Mode (Figure 2.5) to "PIN only" or "None" (you could select "PIN + MAC
list" or "MAC list only" security mode but in this case you need to type external
device MAC address in "Authorized Devices MAC List" (Figure 2.8).
7. Set connection mode to "Hands Free" (Figure 2.6).
8. Set „External Name" as your Hands Free device name for proper device identification
and connection to it. In this example Hands Free headset name is „MBH10" but at
least 2 characters are needed to recognize it and connect to it. For better and faster
Figure 2.1 Load configuration from
device; 2.2 Blue-tooth settings; 2.3 Enable
Blue-tooth; 2.4 Blue-tooth local name; 2.5
Blue-tooth security mode
2.6 Hands Free connection mode;
2.7 External Blue-tooth device name; 2.8
Authorized Devices MAC List; 2.9 Save
device configuration
49