Teltonika FMB001 User Manual page 27

2. Ignition source, where user can choose between power voltage, digital input 1 and
accelerometer ignition sources
3. Object Motion Detection Settings, where user can configure 3 ways how FMB001
will detect stopped movement, and change its working mode (for working modes,
read section 5.8);
4. Static navigation settings, where user can turn static navigation on or off;
5. Static navigation source, where user can choose according to which source static
navigation will work.
6. Records Settings, where user can enable or disable records when GPS is not
available or time not synchronized;
7. GNSS source Settings, where user can choose satellite system.
8. LED indication, where user can turn on or off indication LEDs.
9. Battery charge mode, where user can choose when battery charger is turned on.
Functional purpose
Battery charge mode "On Need" - Enable battery charger any time when needed.
"After Ignition ON" - Charger can be enabled after ignition is turned on, except if
battery is fully charged or 10 minute timeout has not passed since device was
turned on for faster FIX receiving.
10. Time synchronization mode, where you can choose how time synchronization is
done. Possible values:
a) Disable (GPS only) – time is synchronized only from GNSS satellites
b) NITZ – time is synchronized from GNSS satellites or GSM operator (not all GSM
operators support this functionality)
c) NTP – time is synchronized from GNSS satellites or NTP servers.
d) NITZ+NTP – time can be synchronized from GNSS satellites, GSM operator or
NTP server
If necessary, you can configure your NTP servers and how often device should
resynchronize time from NTP (NTP Resync parameter).
Table 5 Configuration parameters
Movement Source
Ignition
(recommended)
Movement
(movement sensor)
GPS
Static Navigation Mode is a filter, which filters out track jumps when the object is
stationary. If Static navigation filter is disabled, it will apply no changes on GPS data. If Static
navigation filter is enabled, it will filter changes in GPS position if no movement is detected
Vehicle on Stop mode
If ignition (DIN1) is logic low
Internal movement sensor does
not detect movement
GPS fix is available and vehicle
speed is lower than 5 km/h
While GPS fix is unavailable, Object Motion Detection Settings are
working like in Msensor mode
Vehicle Moving mode
If ignition (DIN1) is logic high
Internal movement sensor detects
movement
GPS fix is available and vehicle
speed is higher than 5 km/h
27