Installing On A 36" Saw With Overarm Dust Collection - SawStop TSA-FOT Owner's Manual

INSTALLING ON A 36" SAW WITH
OVERARM DUST COLLECTION
On any 36" Contractor Saw, Professional Cabinet Saw, or Industrial Cabinet Saw,
the Folding Outfeed Table and the TSA-ODC Overarm Dust Collection system
are both mounted on the rear rail. For both to mount on the rail as required, while
allowing for folding of the TSA-FOT, you must either:
1. Cut the lower Overarm Dust Collection Tube (Procedure listed below)
- or -
2. Shift the Overarm Dust Collection to the right, extending it 12" past the end of
your extension table (Procedure listed on the next page).
To cut the lower TSA-ODC tube:
Measure 12" from the end of the lower tube, mark the measurement. Cut the tube
at the 12" mark. Install the TSA-ODC per its provided instructions. Refer to
Fig. 57 below.
Tube cut 12" shorter to
allow table to fold
Fig. 57
TSA-FOT OWNER'S MANUAL
PAGES:
54-55
54