SawStop TSA-FOT Owner's Manual page 45

FOR TABLE SAWS WITH PFA RAILS ONLY: Use a 5mm hex L-wrench
to thread an M10 x 20 set screw about halfway into the threaded hole in the
bottom of a rear rail clamp. The non-hex end of the set screw should extend
up toward the top of the clamp, since it will contact the rear rail of the
table saw.
Insert an M6 x 35 socket head cap screw through the hole in the shorter side
of a clamp mounting bracket, then through an M6 x 16 washer, the left side
of the lower hole in the rear rail clamp, a second M6 x 16 washer, and an M6
lock nut.
Repeat this process for two more rear rail clamps, but with the M6 x 35
socket head cap screw facing the opposite direction, so the clamp mounting
bracket is on the right side of the rear rail clamp (see Fig. 40 for reference).
Use a 5mm hex L-wrench and a 10mm wrench to tighten the lock nuts.
DO NOT OVER TIGHTEN THE LOCK NUTS. THE CLAMP
MOUNTING BRACKETS SHOULD BE ABLE TO PIVOT RELATIVE TO
THE REAR RAIL CLAMPS.
Upper hole
Hole in top
of clamp
Lower hole
Hole in bottom of clamp
WITHOUT WING
Fig. 40
TSA-FOT OWNER'S MANUAL
x2
x1
40