SawStop TSA-FOT Owner's Manual page 50

Place two table support tubes (B) on the floor behind your table saw and
12
align them as shown in Fig. 46 The four sets of paired together holes should
be on the left (from the perspective of the user of the table saw), and the two
solitary holes should be on the right.
Support leg
mounting holes
Requires:
Position the two table tubes attached to the insert table across the two table
13
support tubes, as shown in Fig. 47, with the insert table and rear rail clamps
on the end closest to the table saw.
Align the mounting holes in the table tubes with the holes marked as "X" in
Fig. 48. Insert an M6 x 35 socket head cap screw through one of the
exposed mounting holes in one of the table tubes and table support tubes.
Secure the socket head cap screw with an M6 x 16 washer and an M6 lock
nut. Do not tighten the lock nut at this time.
Repeat this process for the remaining three table support tube mounting
holes in the table tubes attached to the insert table.
It is very important to use the correct mounting holes in the table support tubes. Check
i
carefully to make sure the insert table and attached table tubes are aligned correctly.
There should be two holes to the left of the insert table, one hole between the table
tubes, and five holes to the right of the insert table.
45
TSA-FOT OWNER'S MANUAL
WITHOUT WING
Table tube
mounting holes
Table Tube Hardware Pack (1)
Fig. 46
B