SawStop TSA-FOT Owner's Manual page 23

clamp mounting bracket and the table tube with the insert table in the
previous step, then through the hole in the clamp mounting bracket and
the same number of M6 washers you needed between the clamp mounting
bracket and the lock nut in the previous step, and secure the washers with
an M6 lock nut. Use a 5mm hex L-wrench and a 10mm wrench to tighten the
lock nut.
Repeat this process with the last rear rail clamp and set of table tubes
attached to the remaining small table roller. The two assemblies with the
small table rollers should be mirror images of one another. One should have
the rear rail clamp on the left table tube (from the perspective of a user of the
table saw), and the other should have the rear rail clamp on the right table
tube (see Fig. 13 for reference).
E
A
E
A
WITH WING
A
A
Fig. 13
TSA-FOT OWNER'S MANUAL
x1
x1
18