SawStop TSA-FOT Owner's Manual page 16

WITH WING
Place two table tubes (A) on a flat surface, such as a table, with the larger
5
table support tube mounting holes on top, and the table roller mounting
holes on the sides. Insert an M6 x 45 socket head cap screw through an
M6 x 16 washer, then through the roller mounting holes in one of the table
tubes (with the head of the socket head cap screw on the side facing away
from the other table tube), then through two M6 x 10 washers, a ball bearing,
and an M6 lock nut. Use a 5mm hex L-wrench and a 10mm wrench to tighten
the lock nut.
Repeat this process for the other table tube (A).
You should now have two table tubes with the four large table support tube
mounting holes on top, with the heads of the screws facing away from
each other, and the ball bearings between the table tubes (see Fig. 6 or the
exploded view on page 57 for reference).
Press a table roller bushing into each end of a small table roller (E), then
position it between the two ball bearings you just attached to the two table
tubes. Press the ball bearings into the table roller bushings.
Repeat this process with another two table tubes (A) and the remaining small
table roller (E). Set the table tubes with the small table rollers aside.
A
Table Roller
Bushing
x2
E
E
A
A
Fig. 6
11
TSA-FOT OWNER'S MANUAL