SawStop TSA-FOT Owner's Manual page 27

FOR SAWS ONLY: Place the four table support tubes (B) on the floor
behind your table saw and align them as shown in Figure 18. In order to align
the table support tubes, place two tubes next to each other, with the ten
table mounting holes on the top and bottom and the 2 support leg mounting
holes on the sides.
If all the mounting holes align, turn one of the tubes 180 degrees, so only
the mounting holes at the ends line up. Then slide the table support tubes
relative to one another until eight mounting holes on each tube line up, as
indicated by the red circles in Figure 19.
There should be two mounting holes in the non-overlapping portions of each
table support tube. Once the mounting holes are aligned, position the two
table support tubes so the one extending toward the right of the table saw
(from the perspective of the user of the table saw) is further away from the
table saw than the table support tube extending toward the left of the
table saw.
Repeat this process for the other two table support tubes.
Table tube
mounting holes
Support leg
mounting holes
Y Y
B
Y Y
B
WITH WING
Fig. 18
X W
B
X W
B
TABLE SAW
Fig. 19
B
B
W X Z
W X Z
TSA-FOT OWNER'S MANUAL
Z
Z
22