SawStop TSA-FOT Owner's Manual page 14

Press a table roller bushing into each end of the large table roller (F), then
2
press the other side of one of the table roller bushings onto one of the ball
bearings you just attached to a table tube. Do not attach the large table roller
to the other ball bearing yet.
Table Roller
Bushing
F
Place the insert table (D) between the table tubes (A), with the text on the
3
bottom, so the three mounting holes in the side of the insert table line up with
the three insert table mounting holes in the table tube attached to the large
table roller (see Fig. 4).
Be careful when positioning the insert table because it is not yet secured to
the tubes and could scratch the table tubes. Insert an M6 x 40 socket head
cap screw through an M6 x 16 washer, then through one of the exposed
mounting holes in the table tube and insert table, and secure it with a second
M6 x 16 washer and an M6 lock nut. Use a 5mm hex L-wrench and a 10mm
wrench to tighten the lock nut.
Repeat this process for the other two exposed mounting holes in the table
tube attached to the large table roller and the insert table.
9
TSA-FOT OWNER'S MANUAL
WITH WING
F
A
Fig. 3
F
A
D
Fig. 4