SawStop TSA-FOT Owner's Manual page 49

Align the hole in the top of the clamp mounting bracket with the clamp
mounting holes in the end of the table tube. Insert an M6 x 20 socket head
cap screw down through the clamp mounting holes in the table tube, then
through the same number of M6 x 16 washers you needed between the
clamp mounting bracket and the table tube with the insert table in the
previous step, then through the hole in the clamp mounting bracket and
the same number of M6 washers you needed between the clamp mounting
bracket and the lock nut in the previous step, and secure the washers with
an M6 lock nut. Use a 5mm hex L-wrench and a 10mm wrench to tighten the
lock nut.
E
A
11
Install a tube end cap into the open ends of the two table tubes attached to
the small table roller and into the open ends of two solitary table tubes (not
attached to table rollers).
WITHOUT WING
A
Fig. 44
Fig. 45
x2
A
TSA-FOT OWNER'S MANUAL
x1
44