SawStop TSA-FOT Owner's Manual page 31

WITH WING
FOR OR SAWS ONLY: Position a solitary table tube (A) (not
16
attached to a table roller) across the four table support tubes (B), with
the clamp mounting holes on the end closest to the table saw. Align the
mounting holes in the table tube with the set of aligned mounting holes in
the table support tubes just to the side of the table tubes attached to the
insert table (D) (marked as holes "X" in Fig. 16 on page 20).
Position the other solitary table tube (A) on the other side of the insert
table, and align the mounting holes in the table tube with the set of aligned
mounting holes in the table support tubes (B) just to the other side of the
table tubes attached to the insert table (marked as holes "X" in Fig. 16 on
page 20).
Insert an M6 x 35 socket head cap screw through one of the exposed
mounting holes in a table tube and table support tube, then through an
M6 x 16 washer and an M6 lock nut. Do not tighten the lock nut at this time.
Repeat this process for the remaining seven sets of mounting holes in the
two solitary table tubes and table support tubes. See Fig. 24 below for
reference. When finished, skip ahead to page 28.
A
A
Fig. 24
26
TSA-FOT OWNER'S MANUAL