Installing With The Extension Wing - SawStop tsa-sa48 Installation Manual

INSTALLING WITH THE EXTENSION WING

Modifying your table saw to install the Sliding Crosscut Table with the Left
Extension Wing:
If the left ends of the front and rear rails do not extend past the left edge of the left
extension wing, then no modifications are necessary so complete the assembly of your saw and rails then skip
directly to page 8. If the left ends of the front and rear rails do extend past the left edge of the extension wing,
then you will need to shorten your rails so continue to step 1 below.
1. Mark the front rail, rear rail and main tube ¼" to the right of the left edge of the left extension wing.
2. Use a 13mm wrench to remove the bolts from the underside of the main tube. Set it aside.
3. Use a 13mm wrench and 5mm Allen wrench to remove the front and rear rails.
4. Use a metal cutting band saw to cut off the front rail, rear rail, and main tube at the marks made in
Step 1 above.
Using other types of saws (such as a circular saw) can generate enough heat to blister the powder
coating. It is strongly suggested that you use a metal cutting band saw only.
5. Remove any burrs or sharp edges with a file.
6. Remove the plastic end cap from the cut off portion of the main tube and install it on the new left end of the
main tube.
7. If necessary, complete the assembly of your saw then re-install the front and rear rails and the main tube
(refer to your saw and fence manuals).
8. Continue to page 8
SLIDING CROSSCUT TABLE INSTALLATION
7