SawStop TSA-FOT Owner's Manual page 19

FOR TABLE SAWS WITH PFA RAILS ONLY:
L-wrench to thread an M10 x 20 set screw about halfway into the threaded
hole in the bottom of a rear rail clamp. The non-hex end of the set screw
should extend up toward the top of the clamp, since it will contact the rear
rail of the
table saw.
Insert an M6 x 35 socket head cap screw through the hole in the shorter side
of a clamp mounting bracket, then through an M6 x 16 washer, the lower
hole in the rear rail clamp, a second M6 x 16 washer, and an M6 lock nut.
Repeat this process for the remaining three rear rail clamps, but assemble
two of them with the M6 x 35 socket head cap screw facing the opposite
direction, so the clamp mounting bracket is on the other side of the rear
rail clamp (see Fig. 9 for reference). Use a 5mm hex L-wrench and a 10mm
wrench to tighten the lock nuts.
DO NOT OVER TIGHTEN THE LOCK NUTS. THE CLAMP
MOUNTING BRACKETS SHOULD BE ABLE TO PIVOT RELATIVE TO
THE REAR RAIL CLAMPS.
Upper hole
Hole in top
of clamp
Lower hole
Hole in bottom of clamp
WITH WING
Fig. 9
Use a 5mm hex
TSA-FOT OWNER'S MANUAL
x2
x2
14