SawStop TSA-FOT Owner's Manual page 30

WITH WING
Use a 5mm hex L-wrench on the socket screw and a 13mm wrench on the
lock nut to tighten the nut until the support leg (C) can pivot, but still moves
with some resistance.
Repeat the process with the other support leg, but place the remaining
support leg on the other side of the table support tubes (further from the
table saw), with the open end of the support leg on the right and the leveling
foot extending toward the left. Refer to Fig. 22 on page 24.
Slide the rear rail clamps attached to the table tubes with the insert table
15
onto the rear rail of your table saw, keeping the insert table between the
miter gauge slots in your saw table. Use a 5mm hex L-wrench to thread the
set screws into the clamps enough so they engage the rear rail, but do not
tighten them. They need to remain loose so you can align the outfeed table
to the table saw.
Pivot the support legs down so the leveling feet contact the ground. See Fig.
23 below.
Fig. 23
25
TSA-FOT OWNER'S MANUAL