SawStop TSA-FOT Owner's Manual page 44

FOR
L-wrench to thread an M10 x 20 set screw about halfway into the threaded
hole in the top of a rear rail clamp. The non-hex end of the set screw should
extend down toward the bottom of the clamp, since it will contact the rear
rail of the table saw.
Insert an M6 x 35 socket head cap screw through the hole in the shorter side
of a clamp mounting bracket, then through an M6 x 16 washer, the left side
of the upper hole in the rear rail clamp, a second M6 x 16 washer, and an M6
lock nut.
Repeat this process for two more rear rail clamps, but with the M6 x 35
socket head cap screw facing the opposite direction, so the clamp mounting
bracket is on the right side of the rear rail clamp (see Fig. 39 for reference).
Use a 5mm hex L-wrench and a 10mm wrench to tighten the lock nuts.
DO NOT OVER TIGHTEN THE LOCK NUTS. THE CLAMP
MOUNTING BRACKETS SHOULD BE ABLE TO PIVOT RELATIVE TO
THE REAR RAIL CLAMPS.
FOR ICS SAWS (CBFR AND TGI2 RAILS), IT IS VERY IMPORTANT
THAT THE SET SCREW IS INSTALLED IN THE TOP OF THE REAR
RAIL CLAMP, SINCE IT COULD SCRATCH THE MOTOR COVER IF
INSTALLED IN THE BOTTOM OF THE REAR RAIL CLAMP.
Upper hole
Hole in top
of clamp
Lower hole
Hole in bottom of clamp
39
TSA-FOT OWNER'S MANUAL
WITHOUT WING
TABLE SAWS WITH CBFR/TGI2 RAILS ONLY: Use a 5mm hex
Fig. 39
x2
x1