SawStop TSA-FOT Owner's Manual page 56

WITHOUT WING
Slide the Folding Outfeed Table toward the left end of the rear rail on the
19
table saw (from the perspective of a user of the table saw), until the table
tubes attached to the insert table clear the miter slots.
If necessary, use a 5mm wrench to loosen the M10 x 20 set screws on the
rear rail clamps near the insert table. Check to make sure the M10 set screws
in the rear rail clamps do not interfere with any of the holes in the rear rail.
If a set screw interferes with a hole, you can switch the rear rail clamp to
a different table tube. Additionally, you can disassemble the clamp and
reassemble it with the clamp mounting bracket on the other side, which will
allow you to switch the clamp to the other side of the table tube.
Fig. 54
51
TSA-FOT OWNER'S MANUAL