SawStop TSA-FOT Owner's Manual page 20

Position one of the rear rail clamps next to one of the table tubes (A) attached
7
to the insert table (D), so the opening in the rear rail clamp (the side with
the set screw) extends away from the large table roller (F), and the clamp
mounting bracket extends under the table tube. Align the hole in the top of
the clamp mounting bracket with the clamp mounting holes in the table tube,
so the clamp mounting bracket extends under the table tube, but the rear rail
clamp does not.
Insert an M6 x 20 socket head cap screw down through the large and small
clamp mounting holes in the table tube, then through three M6 x 16 washers,
the hole in the top of the clamp mounting bracket, four M6 x 16 washers, and
an M6 lock nut. Use a 5mm hex L-wrench and a 10mm wrench to tighten the
lock nut.
Repeat this process for the table tube attached to the other side of the insert
table. The rear rail clamps should extend away from each other (see Fig. 10
for reference).
F
D
i
No procedure is needed for the other two rear rail clamps at this time, as you will need
to check (and potentially adjust) the height of the table tubes relative to the table saw.
15
TSA-FOT OWNER'S MANUAL
WITH WING
A
A
Fig. 10