SawStop TSA-FOT Owner's Manual page 18

FOR
5mm hex L-wrench to thread an M10 x 20 set screw about halfway into the
threaded hole in the top of a rear rail clamp. The non-hex end of the set
screw should extend down toward the bottom of the clamp, since it will
contact the rear rail of the table saw.
Insert an M6 x 35 socket head cap screw through the hole in the shorter side
of a clamp mounting bracket, then through an M6 x 16 washer, the upper
hole in the rear rail clamp, a second M6 x 16 washer, and an M6 lock nut.
Repeat this process for the remaining three rear rail clamps, but assemble
two of them with the M6 x 35 socket head cap screw facing the opposite
direction, so the clamp mounting bracket is on the other side of the rear
rail clamp (see Fig. 8 for reference). Use a 5mm hex L-wrench and a 10mm
wrench to tighten the lock nuts.
DO NOT OVER TIGHTEN THE LOCK NUTS. THE CLAMP
MOUNTING BRACKETS SHOULD BE ABLE TO PIVOT RELATIVE TO
THE REAR RAIL CLAMPS.
FOR ICS SAWS (CBFR AND TGI2 RAILS), IT IS VERY IMPORTANT
THAT THE SET SCREW IS INSTALLED IN THE TOP OF THE REAR
RAIL CLAMP, SINCE IT COULD SCRATCH THE MOTOR COVER IF
INSTALLED IN THE BOTTOM OF THE REAR RAIL CLAMP.
Upper hole
Hole in top
of clamp
Lower hole
Hole in bottom of clamp
13
TSA-FOT OWNER'S MANUAL
WITH WING
TABLE SAWS WITH CBFR/TGI2 RAILS ONLY:
Fig. 8
Use a
x2
x2