SawStop TSA-FOT Owner's Manual page 35

Slide the Folding Outfeed Table toward the left end of the rear rail on the
18
table saw (from the perspective of a user of the table saw), until the edge of
a table support tube is flush with the end of the rear rail. If necessary, use a
5mm wrench to loosen the M10 x 20 set screws on the rear rail clamps near
the insert table. See Fig. 28 below for reference.
Check to make sure the M10 x 20 set screws in the rear rail clamps do not
interfere with any of the holes in the rear rail. If a set screw interferes with a
hole, you can switch the rear rail clamp to a different table tube. Additionally,
you can disassemble the clamp and reassemble it with the clamp mounting
bracket on the other side, which will allow you to switch the clamp to the
other side of the table tube.
Depending on your saw model,
i
the left side of the outfeed table
may not be flush with the left
side of the extension wing.
Use a 5mm hex L-wrench to tighten the three M10 x 20 set screws to secure
19
the Folding Outfeed Table to the rear rail. Use a straightedge to recheck that
the tops of the table tubes are flush or just beneath the top of the saw table
and make any necessary adjustments.
WITH WING
Fig. 28
TSA-FOT OWNER'S MANUAL
30