SawStop TSA-FOT Owner's Manual page 15

WITH WING
Slide the table tube (A) with the other ball bearing towards the insert table (D)
4
and large table roller (F), and press the ball bearing into the open end of the
table roller bushing in the large table roller.
Align the three insert table mounting holes in the table tube (A) with the
remaining three mounting holes in the insert table (D). Insert an M6 x 40
socket head cap screw through an M6 x 16 washer, then through one of the
exposed mounting holes in the table tube and insert table, and secure it with
a second M6 x 16 washer and an M6 lock nut. Use a 5mm hex L-wrench and
a 10mm wrench to tighten the lock nut.
Repeat this process for the other two exposed mounting holes.
Turn the assembly over, so the large table support tube mounting holes and
the "SawStop" text are on top. Use a straight-edge to make sure the top
surface of the insert table (D) does not extend above the top surfaces of
the table tubes (A). If necessary, loosen the six M6 lock nuts and adjust the
height of the insert table relative to the table tubes, then re-tighten the lock
nuts. Set the table tubes with the insert table and large table roller aside.
F
A
A
D
Fig. 5
10
TSA-FOT OWNER'S MANUAL