SawStop TSA-FOT Owner's Manual page 24

Install a tube end cap into the open ends of the four table tubes attached
11
to the two small table rollers and into the open ends of the remaining two
solitary table tubes (not attached to table rollers). You should have ten
remaining tube end caps, which will be installed later.
FOR
12
floor behind your table saw and align them as shown in Figure 15. In order
to align the table support tubes, place two tubes next to each other, with the
ten table tube mounting holes on the top and bottom and the two support
leg mounting holes on the sides.
If all the mounting holes align, turn one of the tubes 180 degrees, so only
the mounting holes at the ends line up. Then slide the table support tubes
relative to one another until the non-overlapping portions of each tube have
three mounting holes, and four mounting holes on each tube overlap, as
indicated by the red circles in Fig. 16.
Once the mounting holes are aligned, position the two table support tubes
so the one extending toward the right of the table saw (from the perspective
of the user of the table saw) is further away from the table saw than the table
support tube extending toward the left of the table saw.
Repeat this process for the other two table support tubes.
19
TSA-FOT OWNER'S MANUAL
WITH WING
OR SAWS ONLY: Place the four table support tubes (B) on the
Fig. 14
x2
A