SawStop TSA-FOT Owner's Manual page 33

WITH WING
FOR OR SAWS ONLY: Position the set of table tubes with the
17
smaller table roller and the rear rail clamp on the left table tube at the left
end of the table support tubes. The rear rail clamp should be on the table
tube furthest from the insert table. If it is not, place the table tubes with the
small table roller aside and replace them with the other set of table tubes
with the other small table roller.
Slide the rear rail clamp onto the rear rail of your table saw, but do not
tighten the set screw. Align the mounting holes in the table tubes with the
mounting holes at the left end of the table support tubes (marked as holes
"Y" in Fig. 16 on page 20), making sure that tube end caps are almost flush
with the rear rail.
There are two sets of two holes paired together in the top and bottom of
each table tube; you will use the hole in each pair that is closer to the table
saw (see Fig. 26).
Insert an M6 x 35 socket head cap screw through one of the exposed
mounting holes in a table tube and table support tube, then through an
M6 x 16 washer and an M6 lock nut. Do not tighten the lock nut at this time.
Repeat this process for the remaining three sets of mounting holes in the
two table tubes and table support tubes.
Fig. 26
28
TSA-FOT OWNER'S MANUAL