Installing Without The Extension Wing - SawStop TSA-FOT Owner's Manual

INSTALLING WITHOUT
THE EXTENSION WING
i
You will have extra parts and hardware if assembling the Folding Outfeed Table for
installation without the left extension wing.
The first step in assembling the Folding Outfeed Table is to assemble the three table
rollers (E and F) and attach two table tubes (A) to each roller. There are five holes
in the top and bottom surface of each table tube: one solitary hole and two sets of
two holes paired together, and the end with the solitary holes goes near the table
saw. The sets of paired holes are used to mount the table tube to the table support
tubes (B), and the solitary holes are used to attach the rear rail clamps (K) (see
Fig. 32 for reference).
The table support tube mounting holes and clamp mounting holes on the top
surfaces of each table tube are larger than the corresponding holes on the bottom
surface of the table tube. This allows socket head cap screws to be inserted to
secure the table tube to the table support tubes. Not all of the paired holes are used
to mount the table tubes to the table support tubes; different holes are used for
different configurations.
There are five solitary holes in both sides of each table tube: the one furthest from
the clamp mounting hole is the used to attach a table roller to the table tube, and is
not used in every table tube.
The rear three holes on each side of the table tube are used for mounting the insert
table (see Fig. 32 for reference).
33
TSA-FOT OWNER'S MANUAL
WITHOUT WING
Table support tube
mounting holes
Table roller
mounting hole
A
Insert table
mounting holes
Table support tube
mounting holes
Rear rail clamp
mounting hole
Fig. 32
PAGES:
33-53