SawStop TSA-FOT Owner's Manual page 34

WITH WING
FOR SAWS ONLY: Position the set of table tubes with the small table
roller and the rear rail clamp on the left table tube at the left end of the table
support tubes. The rear rail clamp should be on the table tube furthest from
the insert table. If it is not, place the table tubes with the small table roller
aside and replace them with the other set of table tubes with the other small
table roller.
Slide the rear rail clamp onto the rear rail of your table saw, but do not tighten
the set screw. Align the mounting holes in the table tubes with the mounting
holes at the left end of the table support tubes (marked as holes "Y" in Fig.
19 on page 22), making sure that the ends of the table tubes are almost flush
with the rear rail.
There are two sets of holes paired together in the top and bottom of each
table tube; you will use the hole in each pair that is closer to the table saw
(see Fig. 27).
Insert an M6 x 35 socket head cap screw through one of the exposed
mounting holes in a table tube and table support tube, then through an
M6 x 16 washer and an M6 lock nut. Do not tighten the lock nut at this time.
Repeat this process for the remaining three sets of mounting holes in the two
table tubes and table support tubes.
Fig. 27
29
TSA-FOT OWNER'S MANUAL