SawStop TSA-FOT Owner's Manual page 32

WITH WING
FOR SAWS ONLY: Position a solitary table tube (A) (not attached to a
table roller) across the four table support tubes (B), with the clamp mounting
holes on the end closest to the table saw. Align the mounting holes in the
table tube with the left two of the four aligned mounting holes to the side of
the table tube attached to the insert table (D) (marked as holes "X" in Fig. 19
on page 22).
Align the remaining solitary table tube (A) in the same manner, but on the
other side of the insert table. There should be a set of aligned mounting
holes immediately to the right of each of the four table tubes on the four
table support tubes (B).
Insert an M6 x 35 socket head cap screw though one of the exposed
mounting holes in a table tube and table support tube, then through an
M6 x 16 washer and an M6 lock nut. Do not tighten the lock nut at this time.
Repeat this process for the remaining seven sets of mounting holes in the
two solitary table tubes and table support tubes. See Fig. 25 below
for reference.
A
A
Fig. 25
27
TSA-FOT OWNER'S MANUAL