SawStop TSA-FOT Owner's Manual page 28

Requires:
FOR SAWS ONLY: Position the two table tubes (A) attached to the
insert table (D) across the four table support tubes (B), in the middle of the
overlapping sections of the table support tubes, with the insert table and rear
rail clamps on the end closest to the table saw.
Align the mounting holes in the table tubes with the left holes in the two
sets of four aligned holes in the table support tubes (marked as holes "W" in
Figure 19 on page 22). Insert an M6 x 35 socket head cap screw through one
of the exposed mounting holes in one of the table tubes and table support
tubes. Secure the socket head cap screw with an M6 x 16 washer and an M6
lock nut. Do not tighten the lock nut at this time.
Repeat this process for the remaining seven table support tube mounting
holes in the table tubes attached to the insert table.
It is very important to use the correct mounting holes in the table support tubes. Check
carefully to make sure the insert table and attached table tubes are aligned correctly.
i
There should be two sets of aligned holes in the overlapping portion to the left of the
table tubes, and two more solitary holes in the non-overlapping portion of the table
support tube to the left of the table tubes. There should be three sets of aligned holes in
the overlapping portion to the right of the table tubes, and two more solitary holes in the
non-overlapping portion of the table support tube to the right of the table tubes.
23
TSA-FOT OWNER'S MANUAL
WITH WING
Table Tube Hardware Pack
5mm Hex L-Wrench (1)
Fig. 20
10mm Wrench (1)