SawStop TSA-FOT Owner's Manual page 36

WITH WING
Position the remaining set of table tubes at the right end of the table support
20
tubes, and slide the rear rail clamp onto the rear rail of the table saw. Align
the mounting holes in the table tubes with the mounting holes at the right
end of the table support tubes (marked as holes "Z" in Fig. 16 on page 20 or
Fig. 19 on page 22), making sure that the ends of the table tubes are almost
flush with the rear rail of the table saw.
There are two sets of holes paired together in the top and bottom of each
table tube; you will use the hole in each pair that is further from the table saw
(see Fig. 29).
Insert an M6 x 35 socket head cap screw through one of the exposed
mounting holes in a table tube and table support tube, then through an
M6 x 16 washer and an M6 lock nut. Do not tighten the lock nut at this time.
Repeat this process for the remaining three sets of mounting holes in the two
table tubes and table support tubes. Use a 5mm hex L-wrench to tighten the
M10 x 20 set screw to secure the rear rail clamp.
Fig. 29
31
TSA-FOT OWNER'S MANUAL