SawStop TSA-FOT Owner's Manual page 42

WITHOUT WING
Place two table tubes (A) on a flat surface, such as a table, with the larger
5
table support tube mounting holes on top, and the table roller mounting
holes on the sides. Insert an M6 x 45 socket head cap screw through an M6
x 16 washer, then through the roller mounting holes in one of the table tubes
(with the head of the socket head cap screw on the side facing away from
the other table tube), then through two M6 x 10 washers, a ball bearing, and
an M6 lock nut. Use a 5mm hex L-wrench and a 10mm wrench to tighten the
lock nut.
Repeat this process for the other table tube (A).
You should now have two table tubes with the four large table support tube
mounting holes on top, with the heads of the screws facing away from each
other, and the ball bearings between the table tubes (see Fig. 37 or the
exploded view on page 57 for reference).
Press a table roller bushing into each end of a small table roller (E), then
position it between the two ball bearings you just attached to the two table
tubes. Press the ball bearings into the table roller bushings.
Set the table tubes with the small table rollers aside.
A
Table Roller
Bushing
E
E
A
A
Fig. 37
37
TSA-FOT OWNER'S MANUAL